How To Install Glass Window Frame
Take the new glass cut then it measures 1/eight inch shorter than the exact groove dimensions in both the length and width. This creates a i/16-inch gap on each side between the edges of the pane and the rabbet groove. The gap provides room for the glass to expand when the weather changes.
In addition to the replacement drinking glass pane, you'll need: latex glazing putty; metal glazing points; pliers; a heat gun; flexible putty knife; i- or 2-inch, potent, steel, putty pocketknife; and a flathead screwdriver.
Also bank check out these other articles on replacing broken window panes in: steel-casement windows; sliding-sash windows; and metal storm windows.
Use the pliers to remove all of the glass shards.
When you piece of work with broken glass, wear safe goggles as well as gloves; small chips of glass can cause permanent eye damage.
Utilize the estrus gun to warm the old putty; then scrape information technology away with a putty knife.
If the putty doesn't lift off easily, apply more heat and try again. Be patient — the putty around really one-time windows is as hard as concrete, but information technology volition soften.
Don't chisel out the former putty — you might wreck the window. The putty volition soften with plenty heat and time.
Use a putty pocketknife or the tip of a screwdriver to remove the old glazing points.
The points will be buried under the old putty.
Clean and inspect the rabbet groove.
Ensure that no glazing putty, drinking glass shards, or glazing points remain.
Employ a dewdrop of putty on the glass side of the rabbet groove.
Clasp out a 1⁄16-inch dewdrop of putty between the edge of the glass and the window frame.
Gently press downward the glass at the edges to embed the drinking glass into the putty.
Allow the putty to spread out and form a moisture seal on the within of the window between the glass and sash.
Position the new pane in the rabbets.
Shift the pane until you accept a ane/sixteen-inch gap betwixt the pane and sash on all iv sides.
Identify at to the lowest degree two new glazing points in each section of the window sash surrounding the new glass.
Space the points evenly around the perimeter, about half dozen inches apart.
Apply the flat side of a putty knife to push ane corner of each triangular glazing betoken into the wood sash.
You can utilise a screwdriver bract instead of a putty knife.
Class a 1/2-inch-thick rope of putty and press the length forth all four sides of the drinking glass.
Roll a glob of putty between your blank hands to form the rope.
Smooth the glazing putty and scrape away the excess.
Concur the putty knife at a 45-caste angle, press, and smooth the glazing putty against the glass and sash.
After the putty dries completely, repaint the putty and repaired area.
Don't mask off the glass before repainting. The paint volition assistance course a moisture seal betwixt the drinking glass pane and the sash. Then, let the pigment to overlap nigh one/8 inch onto the drinking glass.
Virtually This Article
This article tin exist institute in the category:
- Windows ,
Source: https://www.dummies.com/article/home-auto-hobbies/home-improvement-appliances/windows-home-improvement-appliances/how-to-replace-a-broken-glass-pane-in-a-wood-frame-window-206792/
Posted by: princeaftek1997.blogspot.com
0 Response to "How To Install Glass Window Frame"
Post a Comment